Skip to content

2-year workmanship warranty. Free estimates at (843) 306-2678

Kiawah Island · James Island · Hollywood · Charleston

(843) 306-2678

ServicesGutter Installation

Gutter Installation in Kiawah Island

We install new gutters sized to your roof, hung on hidden hangers driven into solid fascia, and pitched so water leaves at the outlets instead of spilling at the corners. You get a written scope listing materials, footage and each line item before we start.

Two workers on stepladders hold a white gutter along the fascia of a brick house, with trees and a neighboring home in the background on an overcast day

When New Gutters Are the Right Call

Gutter installation makes sense when the system on your home is undersized, pulling away from the fascia, or corroded past the point where patching holds. A 5-inch K-style gutter handles a lot of roofs, but a steep roof with a large drainage area can push more water into the trough than it can carry during a hard summer downpour. That overflow lands at the foundation, splashes up on siding, and soaks the fascia board behind the gutter.

Salt air near the coast is hard on metal. Thin galvanized steel and cheap fasteners rust from the inside of the seams out, and mixing metals, like steel screws in aluminum, speeds up corrosion. We spec materials and fasteners that match, so the parts age at the same rate.

If only a few sections are failing, our gutter repair service may be the better answer. We will tell you which one fits after we look.

What the Installation Includes

Sizing from your roof
We measure roof area and pitch for each run and choose gutter width from that, not from what the old system happened to be. Larger drainage areas get a 6-inch profile.
Removal of the old system
We take down the old gutters, pull the old spikes or hangers, and haul everything away. Spike holes in the fascia get filled or covered by the new hanger placement.
Fascia check before hanging
Every board gets probed before a hanger goes in. Soft or rotted wood cannot hold a screw, so we flag it, photograph it, and price any replacement as its own line on your written estimate.
Hidden hangers and correct pitch
Hangers go roughly every 24 inches, screwed through the fascia into solid wood. Each run slopes about a quarter inch per 10 feet toward its outlet so water does not sit and stain the trough.
Sealed corners and end caps
Corners, end caps and seams get an exterior-grade sealant made for metal gutters. A rushed joint is usually the first spot a new run drips, so each one is wiped clean, sealed and checked before the crew moves down the line.

Signs Your Gutters Need Replacing

  • Overflow in heavy rain

    Water sheeting over the front lip during a storm usually means the gutter is too small or has lost its pitch. Either way, the water is ending up against the foundation.

  • Sagging or pulling away

    A gap between gutter and fascia points to failed spikes or rotted wood. Re-spiking into the same holes rarely holds for long.

  • Rust lines and pinhole leaks

    Orange streaks along the seams or drips from the bottom of the trough mean the metal is thinning. Once corrosion spreads along a run, sealant only buys a short time.

  • Peeling paint or stained fascia

    Water running behind the gutter shows up as blistered paint and dark streaks on the fascia and soffit, often before you notice the gutter itself.

  • Pooling at the foundation

    Puddles or washed-out mulch below the eaves after rain mean water is not being carried away where it should be.

How the Job Runs

  1. 1

    Estimate and measurements

    We walk the roofline, measure each run, check the fascia and note outlet locations. The estimate is free.

  2. 2

    Written scope and pricing

    You get the material, gutter size, linear footage, hanger spacing and any fascia work in writing, each priced on its own line. If an item is not in writing, we do not add it later without asking you first.

  3. 3

    Installation day

    Most homes are done in a single day. We lay drop cloths under the work area, remove the old system, hang and pitch the new gutters, and seal every joint.

  4. 4

    Water test and walkthrough

    We run water through each run to confirm it drains toward the outlets with no standing water, then walk the job with you and clean up the debris and old metal.

Gutter installer on an extension ladder points to a rusted gutter joint on a brick ranch home while the homeowner watches from the yard below

What Moves the Price

Your quote is built from the measurements we take on site. These are the items that make one home cost more or less than another, and each one appears as its own line in writing.

Linear footage and stories
Total length is the base of the price. Second-story and third-story runs take more ladder setup and time than single-story eaves.
Material choice
Aluminum is the common choice and resists corrosion well. Copper costs more up front but weathers to a patina and lasts a long time in salt air.
Gutter size and profile
A 6-inch gutter uses more metal than a 5-inch, and half-round profiles need different hangers than K-style.
Fascia condition
Rotted fascia has to be replaced before new hangers can hold. We only find out by probing it, which is why we check during the estimate.
Roofline complexity
Inside and outside corners, short runs between dormers, and multiple outlet points all add fitting and sealing time.

Gutter Installation Questions

Something not covered here? (843) 306-2678

Aluminum or copper for a home near the ocean?

Both handle salt air better than galvanized steel. Aluminum is lighter and less expensive, and it fits most homes. Copper suits historic or high-end exteriors and holds up for decades, but the material cost is noticeably higher. We can price both side by side in your estimate if you want to compare.

How long does installation take?

Most single-family homes take one day. Larger homes, steep roofs or fascia replacement can stretch it to a second day, and we will tell you that up front in the written scope.

Is there a warranty on the work?

Yes. Our installation work carries a 2-year workmanship warranty. If a joint we sealed leaks or a hanger we set pulls loose in that time, we come back and fix it.

Will the final bill match the quote?

That is how we work. The written estimate lists every item and its price. If we find something unexpected during the job, such as hidden rot behind the old gutter, we stop, show you, and get your okay before doing any added work.

Should I add guards while the gutters are going up?

It is often the easiest time, since the new hangers and the guard can be fitted together. If your roof sits under trees or collects pine straw, ask about our gutter guards and gutter covers during the estimate and we will add them as separate lines.

Do you work outside Kiawah Island?

Yes. We also install gutters in James Island, Hollywood, Charleston, Mount Pleasant and Ravenel.

Brown seamless gutter and downspout with offset elbows on a beige stucco house wall, ending on a splash block in pebble landscaping beside shrubs and a covered patio

Get Your Gutter Quote in Writing

We will measure your roofline, check the fascia and give you a line-item price before any work begins. Get your quote by phone and set a time for us to come out.